The KTuner End-User Rev1 board accepts the bluetooth add-on module to allow bluetooth data logging using the TunerView Android app.

Installation is straightforward:

• Remove the top lid/cover of your K series ECU
• Locate the 4 pin angled male header on the top of the board circled here:
  
  
  
  
• On the back side of the bluetooth module, locate the 4 pin female connector circled here:
  
  
  
  
• Take note of the 4 digit pairing/pin code that is on the back side of your bluetooth module. Write it down, you will need this later.
• Slide the bluetooth module's female connector onto the male header pins until seated as shown here:
  
  
  
  
  
  
• Reinstall the top cover of your ECU. Installation is complete. See the TunerView app for instructions on pairing and datalogging within the app.